User`s manual

Multi-WAN VPN QoS Router
118
10.1.2.1. Gateway to Gateway Setting
The following instructions will guide users to set a VPN tunnel between two devices.
Tunnel No.:
Set the embedded VPN feature, please select the Tunnel number.
Tunnel Name:
Displays the current VPN tunnel connection name, such as XXX Office.
Users are well-advised to give them different names to avoid confusion.
Note: If this tunnel is to be connected to the other VPN device, some
device requires that the tunnel name is identical to the name of the host
end to facilitate verification. This tunnel can thus be successfully
enabled.
Interface:
From the pull-down menu, users can select the Interface for this VPN
tunnel.
Enabled:
Click to activate the VPN tunnel. This option is set to activate by default.
Afterwards, users may select to activate this tunnel feature.
Local Group Setup:
This Local Security Gateway Type must be identical with that of the remote type (Remote
Security Gateway Type).