User`s manual

SmartRG™ Residential Gateways

Creating the WAN Service

WAN Services are created on top of previously created Layer 2 interfaces. To create a WAN service:

1. Select Advanced Setup -> WAN Service and click Add.

2. Select a previously created layer 2 interface from the drop down list and click Next.

3. Select the “WAN Service type” – “PPP over Ethernet” or “IP over Ethernet” are appropriate

choices for routed WAN services. Bridged WAN services will be covered later in the “Bridged

IPTV Configuration” section.

Figure 14 WAN Service Configuration (With or Without VLAN Tagging Support)

NOTE

If VLAN tagging support is desired, set the 802.1p and 802.1q values appropriately.

802.1P: 0 is lowest priority, 7 is highest priority, -1 is unused

802.1Q: -1 indicates no VLAN tagging

NOTE

The SR-350N/NE and SR-500N/NE gateways support mixed VLAN tagged/untagged

traffic on the same WAN interface. Set the untagged WAN connection’s VLAN ID to -1.

4. Click Next.