Installation Instructions

2
The Qolsys Z-WaveAH Plus Module operates at 919.8 / 921.4 MHz with an output power set at 0 dBm
with trace and filter loss is approx.. 1.3 dbi. Data and protocol specifications are beyond the scope of this
document. Please contact Qolsys for the technical specifications.
Pin Configuration:
FCC Compliance:
FCCID: 2AAJXQS-ZWAVE
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in
3.3 v
SRF Rx
SRF Tx
SRF RST
SRF Wake
Not Used
Not used
1 5
2 6
3 7
4 8