User's Manual

www.qomo.com

Using the student keypad for a hardware test, follow these steps:

1. The QClick software must be in the hardware test mode in order to test the student keypad

hardware. Refer to Part 3. Software in session 3.5.3 Hardware test.

2. Under the main menu, select item “6.HardwareTest” submenu to enter into the Hardware

test screen display.

3. Enter the channel number, which is the same as the host machine’s channel number

selected by the PC software.

4. Press the “OK/Menu Key”. If the channel number matches the host receiver channel

number, the PC software will display the student’s keypad ID on a row in a first come first

serve order. Additionally, the register number is also displayed on this test screen in the

keypad. Otherwise, the failure error message will be displayed on the top of this test screen

in the keypad.

(2) Student keypad factory settings:

WARNING: Using this function will clear all user data stored, including all the test answers in this

keypad. It is NOT recoverable.

Sometimes it is convenient to clear all data stored in the keypad. This can be done by simply

restoring the factory settings. This is especially useful when you want to trade in your keypad.

To use the factory settings for the student keypad, follow these steps:

1. Under the main menu, select item “7.Settings” to enter into the Hardware submenu.

2. Under the Setting submenu, select “5.DefaultSet” submenu in order to restore the factory

settings.

3. Press the “OK/Menu Key” to confirm the operation.

4. Follow the screen prompt, and press the menu key to double confirm the setting.

2.1.2.2.9 Student keypad sleep mode:

In order to increase the battery life of the response pads, a sleep mode has been implemented in the

student keypad.

To use the sleep mode settings for the student keypad, follow these steps:

1. Under the main menu, select item “7.Setting” to enter into the Hardware submenu.

2. Under the Hardware submenu, select “3.ScreenSaver” submenu in order to set how long

to enter the sleep mode.

3. Press the “Up/Down Key” to select minute adjust the time.

4. Press the OK/Menu Key to confirm the setting.