Data Sheet

DWM3001C
Fully Integrated UWB Transceiver Module
DWM3001C Data Sheet Rev B, May 2022
Subject to change without notice | All rights reserved
23 of 27
www.qorvo.com
®
10.3 Innovation, Science and Economic Development Canada (ISED)
Note: ISED was formerly Industry Canada (IC).
This device complies with ISED licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device
may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'ISDE applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux
deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority
to operate the equipment.
The OEM integrator is still responsible for testing their end-product for any additional compliance requirements required with this
module installed (for example, digital device emissions, PC peripheral requirements, etc.).
This Module is labelled with its own IC ID. If the IC ID Certification Number is not visible while installed inside another device, then the
end product should display a label on it referring to the enclosed module in a visible area with the following:
“Contains Transmitter Module IC: 23794-DWM3001”
OR
“Contains IC: 23794-DWM3001”
Ce module est étiqueté avec son propre ID IC. Si le numéro de certification IC ID n'est pas visible lorsqu'il est installé à l'intérieur d'un
autre appareil, l'appareil doit afficher l'étiquette sur le module de référence ci-joint. Dans ce cas, le produit final doit être étiqueté dans
un endroit visible par le texte suivant :
“Contains Transmitter Module IC: 23794-DWM3001”
OR
“Contains IC: 23794-DWM3001”
10.4 Regulatory Host Integration Instructions
This module has been granted modular approval for portable applications. OEM integrators for host products may use the module in
their final products without additional FCC / ISED certification if they meet the following conditions. Otherwise, additional FCC / ISED
approvals must be obtained.
• The host product with the module installed must be evaluated for simultaneous transmission requirements. The host integrator
installing this module into their product must ensure that the final composite product complies with the FCC requirements by a
technical assessment or evaluation to the FCC rules, including the transmitter operation. When configuring the module, PC or
Linux console applications such as Tera Term or PuTTY may be used, for more details, contact Qorvo Technical Support.
• Note that antennas mounted on outdoor structures, such as antennas mounted on the outside of a building or on a telephone
pole, or any fixed outdoors Infrastructure are prohibited for use with this device.
• The user’s manual for the host product must clearly indicate the operating requirements and conditions that must be observed
to ensure compliance with current FCC/ISED RF exposure guidelines.
• A label must be affixed to the outside of the host product with the following statements:
• This device contains FCC ID: 2A35D-DWM3001
• This equipment contains equipment certified under IC: 23794-DWM3001
The final host / module combination may also need to be evaluated against the FCC Part 15B criteria for unintentional radiators in order
to be properly authorized for operation as a Part 15 digital device.
If the final host / module combination is intended for use as a portable device (see classifications below) the host manufacturer is
responsible for separate evaluations/approvals for the SAR requirements from FCC Part 2.1093 and RSS-102.