Safety Instructions

S10-Sensor Specification

1. Safety Instructions

Please read this manual carefully before using the product, be familiar with the structure of

the product and master the installation method of the product. Before installation, please confirm

that the product accessories are complete, the product can work normally, and there is no

abnormal appearance and structure. During the installation process, the company shall strictly

abide by the maintenance operation specifications and use professional maintenance tools.

Otherwise, the company will not be responsible for any problems caused by the customer's illegal

operation. If there is any problem in the process of using the product, it must be replaced or

stopped immediately and tested by professional maintenance personnel or after-sales service.

After installing the product, be sure to re-measure the dynamic balance of the tire to eliminate

safety risks。

2. Parameters:

Product Model：S10-Sensor

Storage temperature：-10℃~50℃

Operating temperature：-40℃~125℃

Pressure monitoring range：0-800Kpa

Waterproof grade：IP67

Battery life：4-6years

TPMS Power Level：5-8dBm

TPMS Frequency：433.92MHz & 315MHz

NFC Tags Frequency：13.56MHz ± 7KHz

NFC Tags RF Speed： 26Kbps

Pressure accuracy：±7Kpa

Temperature accuracy：±3℃

Weight：28g（With valve）

Dimensions：approx.51.4mm*27.8mm*13.5mm

Warranty: 2 years

PAGE 1
S10-Sensor Specification 1. Safety Instructions Please read this manual carefully before using the product, be familiar with the structure of the product and master the installation method of the product. Before installation, please confirm that the product accessories are complete, the product can work normally, and there is no abnormal appearance and structure.
PAGE 2
3.Sensor Component diagram： 1 ○ 2 ○ 3 ○ 4 ○ 5 ○ 1 : Tire pressure sensor ○ 2 : Sensor setting screw ○ 3 : Metal valve mouths ○ 4 : Valve retaining nut ○ 5 : valve cap ○ 4. Installation Operation Steps： Step 1: Pass the nozzle through the hub and fix it with the nozzle fixing nut. Note that it is not tightening.
PAGE 3
Step 2: Fix the sensor on the air nozzles with the sensor fixing screw. Note that the sensor should be close to the hub with a torque of 4N•m. Step 3: Tighten the air nozzle fixing nut with a wrench to complete the installation. Note that the wrench uses a torque of 7 N•m.
PAGE 4
FCC Statement： This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.