Installation manual

For Technical Support Call 1-800-247-6557

QRS MUSIC TECHNOLOGIES, INC.

www.qrsmusic.com

PAGE 43

Petine V58.1

Mounting Bracket

Updating Pianomation

If you are upgrading from a previous version of Pianomation MIDI you will need to update the EPROM to version 1.51K. The

version 1.51K EPROM requires a 256 processor, located in processors similar to the ones shown below. The EPROM version

is written on the EPROM which is located on the processor board. Dip switch #3 must be set to the ON position.

EPROM version 1.51K is

required in systems using the

QRS Petine controller. This

goes into the processor lo-

cated under the piano.

Description Part Number

EPROM 1.51K 70570

Processor with 1.51K EPROM 60108

Current version

Released in the year 2000

Piano Automation

Ver 1.30 SN: ****

1.51K

Use this notch to

orient the EPROM in

the correct position.

Note: After installing Petine on the piano flip switch #3 ON.

Dip switches are located on the side of the Year 2000 processor

and inside the enclosure on the previous years enclosures.