AcousticDesign™ Multi-Use Loudspeaker AD-S32T All-Weather 80 mm (3.1”) two-way with shielded woofer and neodymium tweeter with 70V/100V transformer equipped (bypassable) *TD-000139-00* TD-000267-00 rev.
IMPORTANT SAFETY PRECAUTIONS & EXPLANATION OF SYMBOLS 1- Read these instructions. 2- Keep these instructions. 3- Heed all warnings. 4- Follow all instructions. 5- Clean only with a dry cloth. 6- Install in accordance with QSC Audio Product’s instructions and a licensed, professional engineer. 7- Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 8- Only use attachments/accessories from QSC Audio Products, Inc.
Introduction Thank you and congratulations on your purchase of the AcousticDesign™ AD-S32T multiuse, weather resistant loudspeakers. These products represent the state-of-the-art in allweather, lightweight SR (sound reinforcement) loudspeaker systems. To get the most from your investment, we encourage you to review this manual carefully. The AD-S32T loudspeaker systems are full range, high output, two-way designs delivering superior sound quality and high SPL in a lightweight, weather resistant enclosure.
Mounting (continued) Ball Mount Adapter The included ball mount adapter can be attached to almost any flat surface. To use the wall mount adapter, secure the wall adaptor using four to six screws. Ensure the mounting surface is sufficiently strong to support the loudspeaker and any vibration or seismic activity. •Connect the shaft of the mount to the speaker. Tighten the locking nut. •Connect the wiring to the loudspeaker and install the terminal cover, if desired.
Wiring Connect the amplifier’s + and - outputs directly to the loudspeaker’s + and - terminals. The screw terminals accept wire or spade terminals. Use only wire connections when using the input cover. The terminals are spaced (0.38”) (9.66 mm). Maintain proper speaker and amplifier connection polarity throughout the entire system. All positive-marked loudspeaker terminals should be connected to positive-marked amplifier output terminals.
Specifications Frequency Response : 80- 20k Hz (-6 dB) 75hz -20k Hz (-10dB) Drivers: low frequency- 3” (762 mm) magnetically shielded high frequency- 3/4” titanium dome, neodymium magnet structure 1 Maximum Output : (calculated) 99 dB SPL continuous rms output 106 dB SPL peak output Impedance: 8 ohms nominal 6.
Dimensions
Dimensions (continued)
How to Contact QSC Audio Products Cómo comunicarse con QSC Audio Products Comment prendre contact avec QSC Audio Products Kontaktinformationen für QSC Audio Products 联系 QSC Audio Products Mailing address: QSC Audio Products, Inc.
