ISIS Series High Performance Portable Loudspeaker I-82H 203 mm (8”) two-way With Speakon® inputs, pole cup and mic stand adapter I-YM8 Optional Accessory Kit Multi-purpose yoke mount/ floor monitor hardware *TD-000140-00* TD-000140-00 rev.
IMPORTANT SAFETY PRECAUTIONS & EXPLANATION OF SYMBOLS 1- Read these instructions. 2- Keep these instructions. 3- Heed all warnings. 4- Follow all instructions. 5- Clean only with a dry cloth. 6- Install in accordance with QSC Audio Product’s instructions and a licensed, professional engineer. 7- Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 8- Only use attachments/accessories from QSC Audio Products, Inc.
I-82H Introduction Thank you and congratulations on your purchase of the ISIS Series I-82H High Performance Portable Loudspeakers. This product represents the state-of-the-art in lightweight sound reinforcement loudspeaker systems. To get the most from your investment, we encourage you to review this manual carefully. The I-82H loudspeaker system is a full range, high output, twoway design delivering superior sound quality and high SPL in a lightweight, attractive enclosure.
Connection The I-82H has two Speakon® NL4-type connectors wired for full range, passive operation. Connect the amplifier’s + and - outputs directly to the Speakon’s 1+ and 1- terminals. The two connectors are wired in parallel to make parallel cabinet connection easy. Your amplifier must be able to safely power the lower impedance of parallel-connected loudspeakers. EN NL4 to NL4 Wiring (two- and four-conductor cables) Two- or four-conductor cable may be used for Speakon to Speakon connections.
Mounting Stand Alone Mounting If using the loudspeaker only, it can be set on any appropriate surface. The cabinet will lean back at a slight angle when set on a flat surface. Install the four self-adhesive rubber feet on the cabinet bottom to stabilize the loudspeaker and to help prevent it from moving due to cabinet vibration at high output levels. On the back of the loudspeaker, near the bottom, is a safety cable attachment point.
Optional I-YM8 Accessory Kit The I-YM8 Accessory Kit includes a yoke mount bracket, two loudspeaker retaining knobs, two swivel feet with retaining knobs, mic stand adapter, pole cup and retaining knob. The I-YM8 Accessory Kit enables you to mount the loudspeaker to most any surface using the yoke mount bracket, or use as a floor monitor by attaching the two swivel feet. If wall mounting the yoke, we recommend removing the swivel feet.
I-82H Loudspeaker Dimensions EN I-YM8 with I-82H Loudspeaker Dimensions 7
Specifications Frequency Response : 80- 21k Hz (-6 dB) 60- 22k Hz (-10 dB) Maximum Output : (calculated) 113 dB SPL continuous rms output 119 dB SPL peak output Impedance: 8 ohms nominal 7.0 ohms minimum, 210 Hz 135 ohms maximum 1 2 Power Rating : rms (IEC 100 hrs): recommended amp power: 200 watts rms 400 watts rms Sensitivity: 90.5 dB, 1 watt, 1 meter, free field (4 pi) Directivity Index: 500 Hz 1000 Hz 2000 Hz 4000 Hz 8000 Hz 16000 Hz 4.0 5.5 11.7 8.9 8.6 7.
I-82H Beamwidth, Response, and Impedance Curves Beamwidth (degrees) I-82H Horizontal and Vertical Beamwidth Vs. Frequency EN Horizontal Vertical Frequency (Hertz) I-82H Response On-Axis, 20° Off-Axis, 40° Off-Axis, and Impedance Vs. Frequency 20° Off Axis 40° Off Axis Impedance Impedance (ohms) SPL (dB) On Axis Frequency (Hertz) Specifications are subject to change without notice.
Painting the I-82H Loudspeaker The loudspeaker enclosure, grill, and mount can be painted to match any decor, provided the following precautions are observed. The cabinet is made of high impact polystyrene which requires controlled painting procedures in order to obtain good results. Use a paint “system” designed for high impact polystyrene from any reputable paint supplier. 1- Remove the grill. 2- If painting mount and loudspeaker as a unit: Attach the I-YM8. 3- Mask the loudspeaker’s input connector.
How to Contact QSC Audio Products Cómo comunicarse con QSC Audio Products Comment prendre contact avec QSC Audio Products Kontaktinformationen für QSC Audio Products 联系 QSC Audio Products Mailing address: QSC Audio Products, Inc.