QSControl.net™ Wall Control Plate Accessories I N S TA L L AT I O N G U I D E ▼ WCP-1 ▼ WCP-2 *TD-000215-00* *TD-000215-00* Rev. B QSControl.net™ Wall Control Plate Accessories Installation Guide Rev.
QSControl.net™ Wall Control Plate Accessories I. INTRODUCTION The WCP-1 and WCP-2 are wall control plate accessories for QSControl.net network audio system components, such as Basis, RAVE, and DSP products. They allow an installer to create simple, non-computer user interfaces for these products in sound systems. As a result, end users don’t need to learn the QSControl.
R2 Non-QSControl.net applications The WCP-1 can be used for non-QSControl.net analog applications, such as variable passive signal attenuation or a variable voltage divider (see Figure 5). The WCP-1 has two circuit board locations where you can mount resistors to adjust the full clockwise and/or counterclockwise values of the resistances and thereby change the range of attenuation or voltage variation from minimum to maximum.
V. WARRANTY AND DISCLAIMERS QSC Audio Products, Inc. is not liable for any damage to speakers, amplifiers, or any other equipment that is caused by negligence or improper installation and/or use of the WCP wall control plate accessories. PRODUCT RETURN GUIDELINES PRODUCT WARRANTY QSC Audio Products, Inc.
