Owner's Manual

TD-001564-01
2
Suspend the Subwoofer
WARNING!: Do not attach the snap hook to
the loudspeaker or any other load until the
hanger cable has been anchored to a suitable
structural member.
1. Insert the wire cable into the appropriate hole in the slip-lock fastener
(see Figure 1). The fastener’s two holes are directional, so cable will
only insert one way; if it will not go through, the cable is inserted into
the wrong hole.
2. Loop the cable over the structural member where the subwoofer is
to hang. The structure must be capable of supporting at least 5× the
weight of the subwoofer—AD-P.SUB: 17.5 lb or 8 kg.
NOTE: Building codes in some jurisdictions
may require higher safety factors.
Note that the subwoofer uses two hanger cables.
3. Insert the cable through the other hole in the fastener.
4. Adjust the length of the cable hang so the snap hook is at the desired
height. To shorten the hang, simply pull the cable further through one
or both holes in the fastener (Figure 2). To lengthen the hang or to
remove the cable from the structural member, insert the release key
into the appropriate release key hole; this will unlock that hole in the
fastener and allow the cable to move in the other direction (Figure3).
WARNING!: Never insert the release key while
there is a load on the hanger cable.
5. Repeat for the other hanger cables.
6. Attach both snap hooks to the suspension tab on the subwoofer
(Figure 4). Make sure the safety latch on the hook closes fully with the
subwoofer attached before you transfer the weight of the subwoofer to
the cables.
Install the AD-P.SUB Subwoofer
What’s in the AD-P.SUB Box
— Figure 1 —
Insert cable
here
Release
key hole
End view
— Figure 2 — — Figure 3 —
Structural
member
Pull cable to
shorten hang.
Insert release
key to lengthen
hang or remove.
Insert cable
here
Release
key hole
End view
Structural
member
Structural
member
1×
AD-P.SUB
1×
Cover 1
1×
Cover 2
8×
Screw
2×
Hanger cable
with slip-lock
fastener
3×
Euro-style plug
1×
Magnetic
grille
1×
Warranty
1×
Quick Start
Guide
TD-001547