Owner's Manual

TD-001564-01
4
Suspend the Satellite Loudspeakers
WARNING!: Do not attach the snap hook to
the loudspeaker or any other load until the
hanger cable has been anchored to a suitable
structural member.
1. Insert the wire cable into the appropriate hole in the slip-lock fastener
(see Figure 8). The fastener’s two holes are directional, so cable will
only insert one way; if it will not go through, the cable is inserted into
the wrong hole.
2. Loop the cable over the structural member where the loudspeaker is
to hang. The structure must be capable of supporting at least 5× the
weight of the loudspeaker—AD-P.SAT: 0.9 lb or 416 g.
NOTE: Building codes in some jurisdictions
may require higher safety factors.
3. Insert the cable through the other hole in the fastener.
4. Adjust the length of the cable hang so the snap hook is at the desired
height. To shorten the hang, simply pull the cable further through one
or both holes in the fastener (Figure 9). To lengthen the hang or to
remove the cable from the structural member, slide the appropriate
release button on the fastener; this will unlock that hole in the fastener
and allow the cable to move in the other direction (Figure 10).
WARNING!: Never slide either release button
while there is a load on the hanger cable.
5. Repeat for the other hanger cables.
6. Attach the snap hook to the suspension tab on the loudspeaker
(Figure 11). Make sure the safety latch on the hook closes fully
with the loudspeaker attached before you transfer the weight of the
loudspeaker to the cables.
— Figure 8 —
Insert cable
here
End view
— Figure 9 — — Figure 10 —
Structural
member
Pull cable to
shorten hang.
Slide button to
lengthen hang or
remove.
Insert cable
here
End view
Structural
member
Structural
member
Install the AD-P.SAT Satellite Loudspeakers
What’s in the AD-P.SAT Box (Pair Pack)
*Quantities marked with an asterisk (*) are doubled in the Master Pack.
*2×
AD-P.SAT
*2×
Hanger cable
with slip-lock
fastener
1×
Warranty
1×
Quick Start Guide
TD-001547
*2×
Euro-style
plug