Owner's Manual

TD-001564-01

WARNING!: Install the system in accordance

with local building codes and regulations. Some

jurisdictions may require additional suspension

points.

Use a licensed contractor or professional

engineer. QSC is not responsible for damages

that result from negligent installation of any

bracket, hanger, or loudspeaker.

— Figure 11 —

Wire the Satellite

We recommend using insulated twisted pair stranded copper wire of an

adequate gauge to minimize resistive losses. To facilitate connection,

the AD-P.SAT loudspeaker has a two-pole input connector (Figure 12)

and comes with a Euro-style two-pole pluggable connector with clamping

screws for securing to the wire conductors.

1. On the wires from the subwoofer, strip the ends about 6 mm or about

1/4 inch.

2. Connect the pair of wires to the + and - terminals of the Euro-style

connector as shown in Figure 7. Tighten the clamping screws to hold

the wires securely.

Be mindful of polarity when connecting multiple loudspeakers; always

connect + to + and – to –.

3. Plug the connector into the loudspeaker enclosure and tighten its

retaining screws. To strain-relieve the wires, secure them to the

hanger cable using the tie-wraps provided.

SAT

AT 2

SAT 3

SAT 4

From Subwoofer High-Pass Outputs

— Figure 12 —