Owner's Manual

4
ENG
TD-000369-00-B
Using Yoke Mounts
AcousticPerformance Loudspeakers can be installed using a yoke
mount attached to the M10 Integrated Suspension Points. A 6 mm hex
key is required.
• Model AP-5102 (10") uses the AP-YM10 Yoke Mount
• Model AP-5122 (12") uses the AP-YM12 Yoke Mount
• Model AP-5122m (12" multi-purpose) uses the AP-YM12m
Yoke Mount
NOTE: The AP-5122m mounts perpendicular to the
yoke. Refer to Figure 2.
WARNING!: Consult a structural engineer before
mounting the Yoke Mounts to any surface. Be sure the
surface can support the weight of the loudspeaker,
and that the proper bolts are used to secure the yoke to the surface.
1. Properly secure the yoke mount bracket to the selected surface.
Refer to Figure 1 and Figure 2
2. Remove the center M10 hex plugs from the top and bottom of the loudspeaker
enclosure. You may discard or recycle the plugs.
3. Using proper lifting techniques place the loudspeaker in the yoke with the two
circular pads between the top and bottom of the loudspeaker enclosure and
the yoke.
4. Install the M10 socket head cap screw, lock washer, and fl at washer through the
yoke and pad, and into the Integrated Suspension point. Repeat for the other
end of the loudspeaker enclosure. Do not fully tighten the screws at this point.
5. Adjust the angle of the loudspeaker as required.
6. To prevent rattling with models AP-5102 and AP-5122 in a vertical orientation,
install the two rectangular pads between the loudspeaker enclosure and the
yoke mount.
NOTE: If you reposition the loudspeaker be sure to check that the
rectangular pads are in the proper positions.
7. Torque the M10 cap screws to 60 in/lbs.
— Figure 1 —
M10 Cap Screw
Pads
Hex Plug
Split Washer
Washer
— Figure 2 —
M10 Cap Screw
Pads
Hex Plug
Split Washer
Washer