Owner's Manual

ENG

TD-000369-00-B

Connections

AcousticPerformance Loudspeaker are capable of switching between Passive and Bi-amp mode. Look at the Setting ports to determine the current

mode.

Yellow in the Setting port indicates the current mode.

Refer to

Figure 3 and Figure 4

NOTE:

The default mode, from the factory, is the passive crossover network.

Changing from Passive to Bi-amp

All AcousticPerformance loudspeakers ship conﬁ gured in passive mode. To change from Passive to Bi-

amp mode or Bi-amp mode to Passive mode:

Refer to Figure 5 and Figure 6

1. Remove the six screws holding the input cup in place.

2. Remove the input cup, being careful not to place excess stress on the connecting wiring harness.

3. Remove the wiring harness plug from the receptacle at the bottom of the cup.

1. Insert the wiring harness plug into the other receptacle at the bottom of the cup.

2. Turn the input cup over and

verify that yellow is visible in the proper SETTING port

If not, move the plug to the other receptacle.

3. Carefully place the input cup back into position on the enclosure, being careful not to bind

or pinch any of the wires.

4. Secure the input cup with the six screws removed in step 1. Do not overtighten.

— Figure 3 —

Passive mode Bi-Amp mode

— Figure 4 —

Passive Mode

HPF

N/C

1 -

2 -

LPF

NL4 /

Barrier Strip

NL4 /

Barrier Strip

Bi-Amp Mode

1 -

2 -

— Figure 5 —

Remove six

Screws

— Figure 6 —

Passive

Bi-Amp