User manual

4
TD-001570-01-A
Use the Single Hole to Mount the Loudspeaker
This method gives you about 0.6 in. (15.25 mm) shorter distance from the mounting surface to the front of the
loudspeaker.
Do not install the screws/knobs until the loudspeaker yoke mounting points are aligned with the holes in the yoke.
Refer to Figure 6.
1. Make sure the yoke is properly mounted to the desired surface and that the adhesive pads are installed.
2. Make sure the button-head hex screws or the knobs are not threaded into theloudspeaker.
3. Lift the loudspeaker and align the loudspeaker's yoke-mounting points with the single holes in the yoke arms.
4. Insert either the button-head hex screw or knob through the hole in the yoke and thread it into the loudspeaker
yoke-mounting point.
5. Repeat for the other end of the loudspeaker.
6. Tighten enough to keep the loudspeaker at the desired angle.
Tether the Loudspeaker
Refer to Figure 7.
Refer to local codes and requirements for tethering.
Use an appropriate cable (1) attached to the loudspeaker's tether bracket (2) and to a structural part of
the venue. Use appropriate hardware to attach the tether cable to the structure.
Figure 6
Figure 7
2
1
© 2018 QSC, LLC. All rights reserved. QSC and the QSC logo are registered trademarks of QSC, LLC in the U.S. Patent and Trademark office and other countries. All other
trademarks are the property of their respective owners.
http://patents.qsc.com.
Contact QSC
QSC, LLC
1675 MacArthur Boulevard
Costa Mesa, CA 1468‑92626 USA
Main Number: 1.714.754.6175+
Toll Free 800.854.4079
(US Only)
Website: www.qsc.com
Sales and Marketing:
1.714.957.7100+ or
toll free (USA only) 800.854.4079
FAX: [phone]+
E‑mail: [e-mail]
Customer Service
1.714.957.7150+ or
toll free (USA only) 800.772.2834
FAX: [phone]+
E‑mail: [e-mail]