User manual

6
TD-000371-00-A
Front Panel User Interface
The majority of the confi guration for the DXP is performed in the DCP. There a few things that can be changed using the DXP front panel, but the
primary purpose of the LCD and the Page and Set buttons is for status. The following is a breakdown of what you can do and see using the front panel
user interface. Press the PAGE button to move from page to page. Press the SET button to change to edit mode and to modify settings.
NOTE: The DXP ID must be set via the DXP front panel. This identifi es the DXP to the DCP. When creating the confi guration in DCP
Manager that includes this DXP, the same ID must be specifi ed on the DXP confi guration page (Aux/DXP tab in DCP Properties form). If
there is more than one DXP on the CobraNet network, each must have a unique ID.
Page DXP State / Notes LCD Display Settings
1 Initial Boot
Connected and confi gured
QSC DXP
QSC DXP n (1 or 2)
Network name of connected DCP
Status Only
Press PAGE to move to next page.
2 Initial boot
Connected and confi gured
ID:
nn OFFLINE
ID:
nn ONLINE
Press SET cursor moves under fi rst digit of ID number
Press SET to cycle numbers 0-9 for the fi rst digit
Press PAGE to move to second digit of ID number
Press SET to cycle numbers 0-9 for the second digit
Press Page cursor moves under Y of Save? Y:N
Press SET to save and restart the DXP, or
Press Page to move cursor to N
Press Set to exit edit mode without saving
Press PAGE to move to next page.
3 N/A SN xxxxxxxxxx (Serial Number)
FW: 0.00.0000 (Firmware Version)
Status only
Press PAGE to move to next page.
4 N/A Amp Power
ON OFF
Press SET cursor moves to ON
Press SET to turn the amps on.
Press PAGE to move the cursor to OFF
Press SET to put the amps in standby
Press PAGE to move to Exit
Press SET to exit edit mode
Press PAGE to move to next page, or press SET to start over.
5 N/A
+48 VDC phantom power
MIC POWER
OFF (ON)
Press SET to toggle between ON and OFF
Press PAGE to move to next page.
6 N/A MIC SENSITIVITY
27 dBu
Press SET to cycle through the choices:
27 dBu
21 dBu
10 dBu
-16 dBu
Press PAGE to move to next page.
7 AUTO. INPUTS
CC1=0 CC2=0
Status only
Press PAGE to move to next page.
8 N/A
RELAY: 1 2 3 4
OOCC
Press SET to move cursor to Relay #1.
Press SET to toggle between O(pen) and C(lose)
Press PAGE to move to Relay #2.
Press SET to toggle between O(pen) and C(lose)
Continue in this manner. After setting Relay #4, Press PAGE to move to Ex.
Press SET to exit edit mode
Press PAGE to move to next page, or press SET to start over.
9 N/A Contrast
1 - 8
Press SET to toggle through the choices. 1 is high contrast, 8 is low contrast.
Press PAGE to move to next page.
10
Connected and confi gured
No Connection
CobraNet TX RX
OK OK
— — — —
Status only
Press PAGE to move to next page.
11
— — indicates power supply
failure
POWER A B
OK OK
— — — —
Status only
Press PAGE to move to fi rst page.