User manual

user manual
TA-890
TA-890 user manual
Page 87
The grille is a fairly tight fit between the inner edge of the cabinet and the outer surface of the
horn assembly, and can only be removed if it remains parallel with the front edge of the
cabinet; do not attempt to completely lift one end out first. Using two pairs of needle nose
pliers, carefully grip the grille between the perforations and, lifting each end a little at a time,
pull the grille upwards until the returns on the grille clear the cabinet. Set the grille aside.
Once the grille has been removed the horn assembly can now be lifted out. Grasp the horn
assembly firmly by placing both hands inside the high-mid horn moulding. Pull it straight
upwards, making sure it remains parallel with the cabinet front, and away from the cabinet.
To rotate the horn moulding from ‘A’ mode to ‘B’ mode
Lift the horn assembly part-way out of the cabinet and rotate it through 90º so that the high
frequency horn is now orientated towards the top of the cabinet. Lower it carefully back into
the cabinet ensuring that the connecting cables do not snag.