Datasheet

46
TD-000472-00-A
Basic Chorus
The Chorus FX Varies the pitch of a signal at a steady rate to “thicken” a sound.
Home
FX Masters
Select FX
Channel
Effect
FX Masters
FX 1
+
FX
Chorus
Select ChorusSelect Effect
1.
LFO Type Switch – Selects how the pitch will be varied. Sine will vary the
pitch smoothly. Saw will cause the pitch to change abruptly and then ramp
back.
2. LFO Rate Knob – Determines the rate at which the pitch will be varied.
3. LFO Depth Knob – Controls the amount of modulation applied to the
audio signal.
4. Lo Cut Knob – Attenuates, or “cuts” frequencies below this frequency
setting. Range is 20 Hz to 2 kHz.
5. Hi Cut Knob – Attenuates, or “cuts” frequencies above this frequency
setting. Range is 200 Hz to 20 kHz.
Pitch Shift
The Pitch Shift raises or lowers the pitch of an audio signal by fi xed interval. In
addition, the signal can be delayed from the original. The two output channels
can be adjusted independently.
Home
FX Masters
Select FX
Channel
Effect
FX Masters
FX 1
+
FX
Pitch Shift
Select
Pitch Shift
Select Effect
1. Lo Cut Knob – Attenuates, or “cuts” frequencies below this frequency
setting. Range is 20 Hz to 2 kHz.
2. Hi Cut Knob – Attenuates, or “cuts” frequencies above this frequency
setting. Range is 200 Hz to 20 kHz.
3. Left and Right Shift Knobs – Sets the amount of shift, down (-) or up
(+) for the two output channels.
• 100¢ = 1 half step,
• 200 ¢ = 1 whole step,
• 1200¢ = 1 octave
Rotating the Master Encoder will change the amount of pitch shift in
half-step intervals. For fi ner adjustments, hold the Encoder down while
adjusting.
4.
Left and Right Delay Knobs – Adds up to 100 milliseconds of delay to
the Pitch Shift output.
— Figure 43 —
1
234
5
— Figure 44 —
1
2
43