Owner's Manual

32
TD-000472-00-A
Auxes
Auxiliary outputs are used to create a mix for stage monitors, in ear monitors, remote speakers or video / broadcast. There are six (1-6) mono and two
(7/8 – 9/10) stereo Aux mixes.
1.
Auxes Tab – Selects the Aux Sends screen
2. Overview Button – Navigates to the Aux Overview where you can see
and adjust all Aux Sends at one time
3. Aux Master Buttons – Touch one of the Aux Master buttons to go to the
associated Aux output controls.
4. Aux Send Sliders – The Aux Send sets the level of audio sent from the
channel to the Aux output; -40 dB (-Inf) is off.
5. Pre/Post Button – Takes you to the Aux Output channel where you can
change the setting. This setting is for all Aux Sends to the selected Aux
Output. Determines if the Aux signal level is affected by the channel fader
(Post), or is not affected by the channel fader (Pre). Pre is most commonly
used for monitors.
6. Aux Sends Pan Slider – Aux mixes (7/8 & 9/10) always have a pan
control. When two auxes are linked, the even aux’s send control becomes a
pan control. Refer to the Aux Output topic for Aux Linking information.
7. Aux Link Indicator – Indicates the Aux channels are linked. Auxes 7/8
and 9/10 cannot be unlinked. You can link Aux channels from an Input channel Aux Sends screen by touching one of the Aux Master buttons, or
one of the Pre/Post buttons. Both take you to the Aux channel Setup screen where linking is accomplished.
— Figure 24 —
Input
Channels
Pre Fader
Post Fader
LCR
-40 -20 -10 -5 5 10U
EQ Dynamics
Channel
Fader
Channel
Pan
Aux
Sends
Audio
Input
Aux Outputs
Pre/Post
Button
Home Select an
Input Bank
Touch Select
Button
Select
Auxes Tab
In 2
Auxes
Inputs 1-8
— Figure 23 —
2
3
1
7
4
5
6