Owner's Manual

43
TD-000472-00-A
FX Masters
Effect
FX controls common to all Effects. Refer to the individual FX Processor topics for details.
Home Select the FX
Masters Bank
Touch a
Select Button
Select
Effect Tab
Effect
FX Masters
FX 1
1. Effect Tab – Selects the FX Master Effect screen
2. Aux Send Knobs 1 through 10 – Adjust level of processed audio going to
the Aux mixes.
3. Reset Button – Returns processor and Aux Send controls to their default
settings.
4. Preset Label – Name of the current preset. Touch to access the library of Presets.
5. FX Pull-down – Touch to select a different processor.
6. Simple Button – Turns Simple mode on and off. Hides all but the
essential controls on the selected FX. The hidden controls are unique
to the selected FX device. The Mono and Stereo Delays do not have a
Simple mode.
7. Meters – The Input meter displays the incoming audio level before the FX.
The Output meters display the stereo audio level after the FX.
8. FX Master Fader – Controls the level of the FX mix to the Main L/R
Outputs. Select Pre-fader Listening (PFL) or After-Fader Listening (AFL) on
the Mixer Setup screen.
FX Masters − EQ
Controls and displays the settings for the FX Master channel equalization.
Home Select the FX
Masters Bank
Touch a
Select Button
Select
EQ Tab
FX Masters
FX 2 EQ
1. EQ Tab – Selects the FX Master EQ screen.
2. EQ Graph – A graphic representation of the EQ settings. The vertical
measurement is gain, the horizontal is frequency. In the example, the Low
Cut fi lter and the high Shelf fi lter are engaged.
3. Shelf Filter Buttons – 1 (low), 2 (high) – Engages / disengages the
associated shelf fi lter.
4. Low Cut Button – Engages/disengages the low cut fi lter. This fi lter cuts
frequencies below the frequency set by the Freq control.
5. Gain Knob – Adjusts the gain of the associated EQ band over a range of
-15 dB to +15 dB.
6. Frequency Knob – Sets the frequency at a point 3 dB below 0 for the
Low Cut fi lter and 3 dB above (when gain is negative) or below (when gain
is positive) the Gain setting of the associated Shelf Filter.
7. EQ In Button – Engages the equalizer
8. Reset Button – Sets all the EQ controls to their factory default position.
— Figure 38 —
1
6
2
8
5
4
3
7
— Figure 39 —
1
3
2
5
8
4
6
7