User Manual

44
TD-000472-01-C
Output Channel – Speaker Settings
Provides help in properly adjusting QSC K, KW and KLA powered loudspeakers when used with the TouchMix.
Home Select the Aux
Bank
Select
Aux
Select
Main
OR
Select
Setup Tab
Setup
Aux Outputs
Aux 1 Main
or
Speaker Settings
Touch Speaker
Settings
Refer to — Figure 37
1. Select Speaker Button – Touch the button that corresponds with the
QSC K, KW or KLA speaker connected to the output.
2. Set the Gain – Adjust the Gain knob on your loudspeaker to the position
indicated by the illustration and the text (3) below it.
3. When you are finished, touch the Done button.
NOTE: Subwoofer level may be adjusted to get the desired
relative high/low balance.
When the speakers are adjusted as directed, signal to noise ratio
is optimized and the output meters on the TouchMix reflect how
much speaker system headroom is available. Note that the LIMIT
LED on the speakers is not a Clip indicator. It will be lit before the
mixer’s meters indicate any overdrive. This is because the speakers’ DSP is preventing dynamic peaks in the program from overdriving
the amplifier and speakers.
— Figure 37 —
1
3
2
Other Recommended Speaker Settings
K8, K10, K12 KW121, KW152, K153 KLA12 K-Sub, KW181, KLA181
LF
With subwoofer
EXT SUB
No subwoofer
NORM
LF
With subwoofer
EXT SUB
No subwoofer
NORM
LF
With subwoofer
EXT SUB
No subwoofer
NORM
MODE
NORMAL
HF
FLAT
HF
FLAT
ARRAY SIZE
Set to number of KLA12 boxes in
the array
POLARITY
NORMAL
MIC LINE
LINE
(channel A only)
MIC
0