Owner's Manual

6
TD-000472-00-A
Using the Input Channel FX Tab
You can also operate your effects from the input channel area of your mixer.
To Run Effects from the Input Channel:
Welcome to the channel FX screen. From here you can…
Select a Different Processor:
Select a Preset:
Send to the Effect:
Adjust Global FX Parameters (Advanced Mode Only):
These controls are called "global" because all channels using this FX mix are affected by these controls. The Sends fader, however is adjusted for each
individual channel.
Using Pitch Correct:
There is one Pitch-Correct processor available on the mixer. Touch the Enable button to assign it to the currently selected channel.
◦ Use the Blend control to vary the mix between corrected (wet) and uncorrected (dry) signal. 100% wet is used to correct pitch. A blend
between wet and dry is used to provide a doubling effect.
◦ Use the Key control to select a music key. This helps Pitch Correct be more accurate in determining what the intended note is.
◦ Use the Correct Rate control to adjust how quickly the pitch correction tracks.
Inputs 1-8
In 1
FX
1
2
3
4
FX
Lush Reverb
None
Cancel
Select an FX Processor:
1
2
3
4
Presets
See "Select a Preset:" on page 5. Press Home to come back.
-40 -20 -10 -5 5 10U
Adjust the fader for each effect you want to use on this channel.
1170
Delay
mSec
31.0
Feedback
%
Enable
75%
Blend
WetDry
C

/D
Key
5.0
Correct-Rate
(Slow-Fast)