Owner's Manual

48
TD-000472-00-A
Mono and Stereo Delay
These effects delay the audio signal to create echo and similar effects. Controls for the stereo delay may be linked or operated independently.
Home
FX Masters
Select FX
Channel
+
FX
Stereo Delay
Effect
FX Masters
FX 1
Select
Pitch Shift
Select Effect
1.
Lo Cut Knob – Attenuates, or “cuts” frequencies below this frequency
setting. Range is 20 Hz to 2 kHz.
2. Hi Cut Knob – Attenuates, or “cuts” frequencies above this frequency
setting. Range is 200 Hz to 20 kHz.
3. Delay Knob – Sets the time between the dry audio and the
delayed audio.
4. Tap Tempo Knob – Sets the tempo of the regenerations by tapping.
Touch the Tap Tempo button, then tap the Master Control knob at a
steady rate.
5. Regeneration Knob – Adjusts the amount of delayed signal that is sent
back to the input. At 0% only the fi rst echo will be heard. At 99% the echo
will repeat indefi nitely at the same level.
6. Channel Linking Knob (Stereo Delay only) – Links all controls of both
channels. Channel two is set to the same level as Channel one.
Talkback / Noise
This screen controls the routing and level of Talkback and Noise.
Press
Menu
Touch
Talkback
Menu
Talkback
1. Assignments – These buttons select the destination for the noise or
talkback signals.
Note that it is possible to route talkback to the four FX devices. This is very
useful when auditioning and selecting effects.
2. Talk Level – Adjusts the level of the talkback signal to the assigned
outputs. -Inf is off.
3. Talkback Enable – Touch to enable Talkback, touch again to disable
Talkback. Unlike the mixer’s hold-to-talk Talk button, this button is latching.
On the iPad, both Talk and Enable are latching.
4. Noise Level – Adjusts the level of the noise signal to the assigned outputs.
-Inf is off.
5. Noise Enable – Touch to enable Noise, touch again to disable Noise.
— Figure 47 —
1
2
3 4 5 876
— Figure 48 —
1
2
3
4
5