Manual

[phone] www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
156
Typical GVRP Application Topology
To enable dynamic VLAN information register and update among switches, GVRP protocol is
to be configured in the switch. Configure GVRP in Switch A, B and C, enable Switch B to learn
VLAN100 dynamically so that two workstations connected to VLAN100 in Switch A and C can
communicate with each other through Switch B without static VLAN100 entries.
Configuration Item
Configuration description
VLAN100
Port 2-6 of Switch A and C.
Trunk port
Port 11 of Switch A and C, Port 10, 11 of Switch B.
Global GVRP
Switch A, B, C.
Port GVRP
Port 11 of Switch A and C, Port 10, 11 of Switch B.
Connect two workstations to the VLAN100 ports in switch A and B, connect port 11 of Switch A
to port 10 of Switch B, and port 11 of Switch B to port 11 of Switch C.
The configuration steps are listed below:
Switch A:
Switch(config)# gvrp
Switch(config)#vlan 100
Switch(Config-Vlan100)#switchport interface ethernet 1/2-6
Switch(Config-Vlan100)#exit
Switch(config)#interface ethernet 1/11
Switch(Config-If-Ethernet1/11)#switchport mode trunk
Switch(Config-If-Ethernet1/11)# gvrp
Switch(Config-If-Ethernet1/11)#exit
Switch B:
Switch(config)#gvrp
Switch(config)#interface ethernet 1/10
Switch(Config-If-Ethernet1/10)#switchport mode trunk
Switch(Config-If-Ethernet1/10)# gvrp
Switch(Config-If-Ethernet1/10)#exit
Switch(config)#interface ethernet 1/11
Switch(Config-If-Ethernet1/11)#switchport mode trunk
Switch(Config-If-Ethernet1/11)# gvrp
Switch(Config-If-Ethernet1/11)#exit