Manual

[phone] www.qtech.ru
Москва, Новозаводская ул., 18, стр. 1
218
Configuring Originator RP
Configuring TTL value
Configuration of MSDP entities
Configuring the Connect-Source interface
Configuring the descriptive information for MSDP entities
Configuring the AS number
Configuring the specified mesh group of MSDP
Configuring the maximum size for the cache
Configurations on delivery of SA packets
Configuring filter policies for creation of SA packets
Configuring filter rules on how to receive and forward SA packets
Configuring SA request packets
Configuring filter policies for SA-Request packets
Configuration of parameters of SA-cache
Configuring SA packets cache
Configuring the aging time for entries in SA packets cache
Configuring the maximum size for the cache
28.4.3 Configuration of MSDP Basic Function
All the commands in this section are configured for RP in the PIM-SM domain. These RP will
function as the other peer of the MSDP entities.
28.4.3.1 Prerequisites of MSDP Configuration
Before the MSDP basic functions can be configured, the following tasks should be done:
At least one single cast routing protocol should be configured, in order to connect the network
inside the domain and outside
Configure PIM-SM in order to implement multicast inside the domain
When configuring MSDP basic function, the following information should be ready:
The IP address of MSDP entities
Filter policy table
Pay attention: MSDP can not use with Any-cast RP at same time, but configure Any-cast RP of
based MSDP protocol.
28.4.3.2 Enabling MSDP
MSDP should be enabled before various MSDP functions can be configured.
Enable the MSDP function
Configure MSDP