Installation Instructions
This device was tested for operations. To comply with RF exposure
requirements, a minimum separation distance of 20cm must be
maintained between the user’s body and the charger, including the
antenna. Third-party belt-clips, holsters, and similar accessories used by
this device should not contain any metallic components. Body-worn
accessories that do not meet these requirements may not comply with RF
exposure requirements and should be avoided. Use only the supplied or an
approved antenna.
The device is in compliance with the essential requirements and other relevant
provisions of the UK Radio Equipment Regulations SI 2017:1206 (as amended).
1. The device complies with RF specifications when the device used at 20cm
form your body.
Declaration of Conformity:
Hereby, Annex Products Pty Ltd declares that the product “Dual Desktop
Wireless Charger” is in compliance with the following Directives: Radio
Equipment Regulations 2017, Electrical Equipment (Safety) Regulations
2016 and The Restriction of the Use of Certain Hazardous Substances in
Electrical and Electrical Equipment 2012. The full text of the UK declaration
of conformity is available at the following internet address: https://www.
quadlock.com.au/compliance
Radiated H-Field 5.3 dBμA/m (@10m) (only for EU and UK)
TX/RX frequency range 110-148KHz (only for EU and UK)
INDUSTRIE CANADA (IC: 27134-QLH2)
IC Caution:
Radio Standards Specification RSS-Gen, issue 5
This device contains licence-exempt transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic Development Canada’s licence-
exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that
may cause undesired operation of the device.
RF exposure statement:
The equipment complies with IC Radiation exposure limits set forth for
uncontrolled environments. This equipment should be installed and operated
with a minimum distance of 10cm between the radiator and your body.
IC Caution:
Cet appareil contient des émetteurs / récepteurs exemptés de licence
conformes aux RSS (RSS) d’Innovation, Sciences et Développement
économique Canada. Le fonctionnement est soumis aux deux conditions
suivantes:
(1) Cet appareil ne doit pas causer d’interférences.
(2) Cet appareil doit accepter toutes les interférences, y compris celles
susceptibles de provoquer un fonctionnement indésirable de l’appareil.
Annex Products Pty Ltd, Australia, declares that the products “MAG
Wireless Charger Head, Model No. QL-3954-M”, complies with part
15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this
device must accept any interference received, including interference that
may cause undesired operation.
NOTE: The “MAG Wireless Charger Head” has been tested and found to
comply with the limits for a Class B device, pursuant to Part 15 of the FCC
Rules and has been assigned FCC ID: 2AOU9-QLH2. These limits are designed
to provide reasonable protection against harmful interference. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to
which the receiver is connected.
• Consult the dealer or an experienced technician for help.
The equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with a minimum distance of 20cm between the radiator and your body. Use
only supplied antenna.
CAUTION: Any changes or modifications in construction of these devices
which are not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This device was tested for operations. To comply with RF exposure
requirements, a minimum separation distance of 20cm must be
maintained between the user’s body and the handset, including the
antenna. Third-party belt-clips, holsters, and similar accessories used
by this device should not contain any metallic components. Body-
worn accessories that do not meet these requirements may not
comply with RF exposure requirements and should be avoided. Use only the
supplied or an approved antenna.
This device in compliance with the essential requirements and other relevant
provisions of Directive 2014/53/EU. All essential radio test suites have been carried
out. This restriction will be applied to all Member States of European Union.
1. The device complies with RF specifications when the device used at 20cm
form your body
Declaration of Conformity
Hereby, Annex Products Pty Ltd declares that the product “Dual Desktop
Wireless Charger” is in compliance with Directives 2014/53/EU & 2011/65/EU.
The full text of the EU declaration of conformity is available at the following
internet address: https://www.quadlock.com.au/compliance