Specifications

User Manual AGCO AgCam® Combine Kit
Page 6 of 20 Rev: 03/10/14
1. Locate the bracket mounting hole on the front side of
the front, right hand cab post.
2. Secure bracket to post temporarily using standard bolt.
3. Position bracket on post so that display mounting tabs
are level.
4. Using a pencil, mark the location on the post for the 2
nd
screw.
5. Remove the bolt that was temporarily installed in step
2 and set the bracket aside.
6. Drill a 7/32”diameter hole in the post at the location
marked in step 4.
7. Place bracket on post and install using the standard
bolt on the front (left) side and a thread rolling screw
on the rear (right) side.
5. INSTALLING YOUR C2100 VIDEO ADPATOR
For BUSBK-C2 kits only.
1. Plugs into Quick Connect port located behind headliner (see section 5 for location).
2. Plugs into USB port on rear of C2100 monitor.
IMPORTANT: C2100 Monitors can ONLY display 2 cameras.