Specifications
4100-I ACT Wood Insert
R
Minimum Width of Cavity Opening
Inches Millimeters
permissible:
•
pipe or chimney liner,
• xternal trim pieces which do not affect the operation of
removed.
•
accommodate the insert, and must be returned to original
Figure 11.2
•
the portion of the insert extending onto the hearth must be
supported.
•
ordered from your dealer.
•
the authority having jurisdiction.
Damper
Doors
The following parts may be removed:
Prefabricated Metal Chimney (Cont’d)
LINER CONNECTOR
FLUE
GAS
DIRECTION
CRIMPED
END
TOWARDS
STOVE
Figure 11.1
NOTE:
NOT allowed.
NOTICE:
ney it must be safety listed, Type UL103 HT (2100
o
F)
[1149
o
C] CLASS “A” or conforming to CAN/ULC-
S629M, STANDARD FOR 650
o
C FACTORY-BUILT
CHIMNEYS.
NOTE: Refer to chimney liner manufacturer for recom-
mendations on supporting the liner. Installation into
replaces without a permit will void the listing
Altering the Fireplace
Securing Chimney Components
tions must be attached to the insert and to each other with the
crimped (male) end pointing toward the insert. Figure 11.1
.
WARNING! Risk of Fire!
Follow venting manufacturer’s clearances and instructions
when installing venting system.
250-2061
WARNING
THIS FIREPLACE MAY HAVE BEEN ALTERED
TO ACCOMMODATE AN INSERT. IT MUST BE
RETURNED TO ITS ORIGINAL CONDITION
BEFORE USE AS A SOLID FUEL BURNING
FIREPLACE.
250-2061
Figure 11.2