Specifications
4100-I ACT Wood Insert
R
VENTING REQUIREMENTS
Chimney Systems
Approved Masonry Chimney:
without a stainless steel liner may reduce draw which
produce excessive creosote).
•
•
chimney area).
•
or other approved material.
this cannot be accomplished, it will be necessary to
remove the damper
connector with a high temperature sealant or seal
Minimum 1/2” (25mm) Air Space,
Maximum 4” (102mm) Air Space
Airtight Clean-
Out Door
Minimum 5/8” (16mm)
Fireclay Flue Liner
Non-Water Soluble
Refractory Mortar
4“ (102mm) Masonry
or Modular Block Wall
(Nominal)
12” (305mm) if Rubble
Stone Wall (Nominal)
Footing (depth and size of footing
accordance with local building code)
Figure 8.1
Venting Systems
Chimney Connector:
Chimney:
WARNING! Risk of Fire!
Follow venting manufacturer’s clearances and instructions
when installing venting system.
Inspections
Fire Risk
Inspection of Chimney:
• Chimney must be in good condition.
WARNING
NOTICE:
Larger Chimneys
It is recommended that chimneys with larger diameters than
up of creosote.