Owner`s manual

Page 36
7021-130F
May 12, 2014
Castile-B FS Pellet Stove
I. Glass Replacement
• Glass is 5mm thick high temperature heat-
resistant ceramic glass.
• DO NOT REPLACE with any other material.
• Alternate material may shatter and cause
injury
WARNING
1. Open the face and remove door from the appliance
by lifting door off of hinge pin and lay on a fl at surface
face down.
2. Using a screwdriver, tap the bottom of the rope retainer
rod to push it up out of the hole. The top end of the
rod will slide up. Swing the rod toward you from the
bottom and remove the rod. Repeat for other side.
3. Remove old glass and replace with new glass.
Glass
Rope Retainer
Rods
Crimped end
at the bottom
Crimped end must be
parallel with the glass
Slide top
end in first
Figure 36.2
H. Igniter Replacement
1. Turn down thermostat, let the appliance completely
cool and then unplug appliance before servicing.
2. Open the ash door and remove the ash pan. Remove
the right side panel by loosening 2 screws (do not
remove) and pull side panel away.
3. The wire leads to the igniter are connected to the
wire harness (black wires) with 1/4 inch male / female
spade connectors. Disconnect the spade connections.
Loosen the thumb screw and slide igniter out.
4. Install new igniter into the chamber and tighten the
thumb screw.
5. Re-connect the wires to the 2 leads with the spade
connectors. Double check that the igniter wires are
clear of any movement, i.e. ash pan, fi repot cleaning
rod, cleaning slide plates, etc.
6. Re-install the ash pan, close the ash removal door.
Thumb Screw
Igniter
Igniter
Bracket
Figure 36.1
4. Slide the retainer rod into the top hole fi rst, and then
line up the bottom crimped end with the hole in the
door. The crimped end must be parallel with the glass
in order to insert it into place. Figure 36.2.
J. Damaged/Broken Component
Replacement
1. Replacement of broken or damaged components
should only be completed by a trained or qualifi ed
technician.
2. In the event that you fi nd a damaged component,
please contact your local dealer, to send a service
technician to complete the removal and replacement
of the parts.