Owner`s manual

Page 4
7021-130F
May 12, 2014
Castile-B FS Pellet Stove
1
Listing and Code Approvals
A. Appliance Certi cation
E. BTU & Ef ciency Speci cations
NOTE: This installation must conform with local codes.
In the absence of local codes you must comply with the
ASTM E1509-95, ULC S627-00 ULC/ORD-C-1482-
M1990 (UM) 84-HUD
Model: Castile Pellet Stove
Laboratory: OMNI Test Laboratories, Inc.
Report No. 061-S-77d-6.2
Type: Solid Fuel Room Heater/Pellet Fuel Burn-
ing Type
Standard: ASTM E1509-04, ULC S627-00 and ULC/
ORD-C1482-M1990 Room Heater Pellet
Fuel Burning type and (UM) 84-HUD,
Mobile Home Approved.
C. Glass Speci cations
This appliance is equipped with 5mm ceramic glass.
Replace glass only with 5mm ceramic glass. Please con-
tact your dealer for replacement glass.
D. Electrical Rating
115 VAC, 60 Hz, Start 4.1 Amps, Run 1.1 Amps
NOTE: Some generator or battery back-up systems
may not be compatable with the micro-processor elec-
tronics on this appliance. Please consult the power
supply manufacturer for compatable systems.
NOTE: Hearth & Home Technologies, manufacturer of
this appliance, reserves the right to alter its products,
their speci cations and/or price without notice.
WARNING! Risk of Fire! Hearth & Home Technologies dis-
claims any responsibility for, and the warranty and agency
listing will be voided by the above actions.
DO NOT:
Install or operate damaged appliance
Modify appliance
Install other than as instructed by Hearth & Home
Technologies
Operate the appliance without fully assembling all
components
Over re
Install any component not approved by Hearth &
Home Technologies
Install parts or components not Listed or approved.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a quali ed
installer, service agency or your dealer.
Quadra-Fire is a registered trademark
of Hearth & Home Technologies.
This appliance is approved for mobile home installations
when not installed in a sleeping room and when an outside
combustion air inlet is used.
The structural integrity of the mobile home oor, ceiling, and
walls must be maintained.
The appliance must be properly grounded to the frame of
the mobile home and use only Listed pellet vent Class “L”
or “PL” connector pipe.
A Quadra-Fire Outside Air Kit must be installed in a mobile
home installation. You must order the Outside Air Kit sepa-
rately.
B. Mobile Home Approved
Note: The appliance is also approved for installation
into a shop.
*BTU output will vary, depending on the brand of fuel you
use in your appliance. Consult your Quadra-Fire dealer for
best results.
Particulate
Emissions Rating:
1.8 grams/hr
*BTU Output: 8,500 - 28,200 / hr
Heating Capacity: up to 1,500 sq. ft. depending on
climate zone
Hopper Capacity: 45 lbs
Fuel: Wood Pellets or Shelled Corn
Shipping Weight: 214 lbs
Ef ciency 78%
These heaters meet the US Environmental Protection
Agency’s emissions limits for pellet heaters. Under speci c
conditions the PS35 stove has been shown to deliver heat
at rates ranging from 8,500 to 28,200 BTU/hr.