Owner`s manual

20 7036-187 January 29, 2014
MT. VERNON AE INSERT
READY
71
Set at: 68
12:30 PM
HEAT OUTPUT
MENU
Medium High
1. At the starting screen, press “HEAT
OUTPUT”.
2. Usethe“UP”buttontochange“HEAT
OUTPUTLEVEL”to”MEDIUM-HIGH”.
SETTING HEAT OUTPUT
1. Pressandhold“UP”or“DOWN”but-
ton to set desired temperature.
74
ºF
2. Press“HOLDTEMP”.
SETTING COMFORT LEVEL
READY
71
Set at: 68
12:30 PM
HEAT OUTPUT
MENU
NOTE: Set temperature must be 3
degrees higher than room
temperature for appliance to
start.
SET COMFORT LEVEL
ON HOLD
RESUME
DONE
74
ºF
3. Press“DONE”.
3. Press “DONE” twice or wait 15 sec-
onds for starting screen to re-appear.
HOPPER OUT OF FUEL
SHUTDOWN
71
Set at: 74
12:30 PM
HEAT OUTPUT
MENU
Hold at:
STARTUP
71
Set at: 74
12:30 PM
HEAT OUTPUT
MENU
Hold at:
Min Firepot Temp
SERVICE
RETRY
ERROR LIST
1. If the appliance has stopped operat-
ing,checkthewallcontrolscreen.If
it is showing “Min Firepot Temp” the
hopper has run out of fuel.
2. Fill the hopper with fuel and press the
“RETRY”buttontwice.Thersttime
turns on the back light, the second
time starts the retry function.
3. If the wall control screen changes to
a “SHUTDOWN” screen that means
your appliance has not completed the
full shutdown cycle. Depending on
whereit wasin the cycle it cantake
from one to ten minutes to restart.
When the shutdown cycle is complete
the wall control screen will display
“STARTUP”. Continue to Step 4.
4. If the wall control screen changes to
a “STARTUP” screen after pressing
“RETRY” that means your appliance
has already completed the shutdown
cycle. You must wait until the wall
control screen displays the startup
screenandthenput1/2cupofpellets
intherepotforaquickrestart.
5. Besurethehopperlidandglassdoor
arebothclosed.