Owner`s manual

Quadra-Fire • QFI30FB-C, QFI35FB-C • 2221-901 Rev. S • 2/15 36
H. Install the Log Assembly
Log Set Assembly: LOGS-QFI35FB
Models: QFI35FB, QFI35FB-C
CAUTION: Logs are fragile, handle with care.
Glass Rock (2201-853): Fill each light tray evenly with the glass rock.
WARNING! Risk of Explosion! DO NOT place glass rock on the burner surface. DO NOT place glass rock directly over
burner ports. Improperly placed glass rock interferes with proper burner operation.
Figure 3. Install Glass Rock
Figure 4. Place Log #1 Figure 5. Place Log #2
Figure 1. Logs Installed
GRATE TINES
GRATE TINES
PILOT BRACKET
PILOT BRACKET
LOG PINS
LOG PINS
LIGHT TRAYS
LIGHT TRAYS
LOG SUPPORTS
LOG SUPPORTS
GRATE BAR
GRATE BAR
6
6
5
5
1
1
2
2
4
4
7
7
3
3
Figure 2. Reference Points for Log Placement
Log #1 (SRV2223-703): Position Log #1 as shown in Figure 4. See Figure 2 for additional points of reference. Center the
log over the pilot bracket. The log should rest on the burner ledge as shown in Figure 4.
Log #2 (SRV2223-701): Position Log #2 as shown in Figure 5. See Figure 2 for additional points of reference. Place the
left end of the log on the rear log support. Slide the log back until it rest against the back of the log support. The left end of
the log should touch Log #1. Swing the right end of the log counterclockwise until it contacts the right refractory wall.
GLASS ROCK
GLASS ROCK
FLAT SPOT
FLAT SPOT
FOR LOG #7
FOR LOG #7
FLAT SPOT
FLAT SPOT
FOR LOG #6
FOR LOG #6
LOG #1 CONTACTS BURNER
LOG #1 CONTACTS BURNER
LEDGE AT TWO POINTS
LEDGE AT TWO POINTS
CENTER LOG CUT OUT
CENTER LOG CUT OUT
OVER PILOT BRACKET
OVER PILOT BRACKET
LOG #2 TOUCHES
LOG #2 TOUCHES
LOG #1 HERE
LOG #1 HERE
LOG #2 CONTACTS
LOG #2 CONTACTS
RIGHT FIREBOX WALL
RIGHT FIREBOX WALL
1
1
2
2
1
1
BURNER LEDGE
BURNER LEDGE
BURNER
BURNER
LEDGE
LEDGE
SRV2223-703
SRV2223-703
SRV2223-701
SRV2223-701
SRV2223-702
SRV2223-702
SRV2223-704
SRV2223-704
SRV2223-706
SRV2223-706
SRV2223-705
SRV2223-705
SRV2223-707
SRV2223-707