Owner`s manual

Quadra-Fire • QVI30S, QVI35S • 340-901 Rev. i • 6/09

Figure 11.1 Placement of Embers

Appliance Setup

A. Remove Shipping Materials

Remove shipping materials from inside or underneath the

ﬁ rebox.

B. Clean the Appliance

Clean/vacuum any sawdust that may have accumulated

inside the ﬁ rebox or underneath in the control cavity.

C. Accessories

Install approved accessories per instructions included with

accessories. Contact your dealer for a list of approved ac-

cessories. Refer to Section 16.

Shock or ﬁ re risk.

Use ONLY optional accessories approved for

this appliance.

• Using non-listed accessories voids warranty.

• Using non-listed accessories may result in a

safety hazard.

• Only Hearth & Home Technologies approved

accessories may be used safely.

D. Ember Placement

Explosion Risk.

• Follow ember placement instructions in manual.

• Do NOT place embers directly over burner ports.

• Replace ember material annually.

Improperly placed embers interferes with proper burner

operation.

Placing the Ember Material

Ember material is shipped with this gas appliance. To place

the ember material:

• Embers CANNOT be placed directly over ports.

• When placing Glowing Embers® onto the burner care

should be taken so that the ports are not covered. Place

the dime-size ember pieces near port holes in burner

top, sides and front (see Figure 11.1). Failure to follow

this procedure will likely cause lighting and sooting

problems.

• Place Mystic Ember over burner surface and around

base of burner. Do not cover any burner port holes. Use

this material to give the appliance a realistic ash bed.

• Save the remaining ember materials for use during

appliance servicing. The embers provided should be

enough for 3 to 5 applications.

WARNING

EMBER MATERIAL/BRAISES