Pro11 Headset System Installation Manual Pro11 Headset Q-P11HS Pro11 Base Station Q-P11BS Pro11 Charger Q-P11CH
STEP 1 STEP 2 • The base station can be located in • Set up the 6-port battery charger. either the OR or the monitoring room. Select a clear desk or cabinet top in the monitoring room close to a power socket that DOESN’T get switched off or unplugged at night. (figure 2) • Identify a location with clear space around it and nothing in front (the base is a transmitter). (figure 1) • You need a power socket close by.
STEP 3 STEP 4 • Place a battery into each headset, by • To register a headset to the base station, removing the outer sleeve on the body of the headset using your fingernail. (figure 4) take one headset at a time out of the charger and hold the outside face of the headset to the bottom of the base. (figure 5) • Remove the tape over the battery contacts, then slot the battery into the chamber. It only goes in one way, so turn it over if it won’t slide in. Clip the sleeve back on.
Useful information • If you have multiple ORs and multiple Pro11 systems you can move headsets from one room to another by following Step 4 overleaf. When a headset is registered to another base station it automatically deregisters from the previous one. • If you hear 2 beeps in your ear, it means you’ve gone out of range. Move back towards the base station it’s registered to and the headset will reconnect. • Batteries will last for 16 hours on standby and up to 10 hours in hands-free mode.
Regulatory Notices Headset - HVIN: Q-P11HS FCC ID: UDDQP10HS This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
www.quaildigital.