User's Manual

©QTI Page 14 Revision: F
Form #: 30Z0138 Effective Date: 24 August 2006
EMIDS Transmitter (MMCT) Programming
Program 901: Fixed Channel Mode (Changing the channel after initial set-up)
Program 901 is used for Low Frequency Band transmitters, Channels 001-600.
For High Frequency Band transmitters, Channels 001-999, use Program 920.
For High Frequency Band transmitters, Channels 1000-1920, use Program 921.
For Medium Frequency Band transmitters, Channels 001-999, use Program 950.
For Medium Frequency Band transmitters, Channels 1000-1600, use Program 951.
1. Set the switches to “000” – Press and release the test
button, the LED should turn to Amber. The unit is now in
the programming mode.
2. Set the switches to “901” for LB channels 001-600 (or
other corresponding program number as described above)
– Press and release the test button, the LED should blink
once and return to Amber. The unit is ready to accept the
channel number.
3. Set the switches to the desired channel number. (In this
example “345”). Press and release the test button, the LED
should turn Green for two seconds. Channel “345” is
selected.
NOTE 1: If the LED is Red at the end of step 3, an error has occurred. Repeat the procedure, otherwise no
programming will occur.
NOTE 2: The channel number may be 001- 600 for LB, 001-1600 for MB, or 001-1920 for HB. Channel number 000
should not be used.
Program 902: Fixed ID Mode (Changes and locks in transmitter identification code)
NOTE: The ID number may be 001-999. In the EMIDS Mode, or 01-63 in the MIDS Mode.
1. Set the switches to “000” – Press and release the test
button, the LED should turn to Amber. The unit is now in
the programming mode.
2. Set the switches to “902” – Press and release the test
button, the LED should blink once and return to Amber.
The unit is ready to accept the ID number.
3. Set the switches to the desired ID number. (In this example
“044”). Press and release the test button, the LED should
turn Green for two seconds. ID Code “044” is set.
For ease of identifying transmitters, before deployment, apply a piece of tape to the transmitter (not the battery cap) and mark
the ID code on the tape.
Amber
Blinks
Remains
Amber
Green - OK
Red - Error
Amber
Green - OK
Red - Error
Blinks
Remains
Amber