User's Manual

©QTI Page 17 Revision: F
Form #: 30Z0138 Effective Date: 24 August 2006
EMIDS Transmitter (MMCT) Programming
Program 910 to 915: State of Health Messages
A State-of-Health message, depending on the program, will be transmitted. This message confirms that the transmitter is
working properly. “Test” will be displayed on the receiver display along with the ID code of the transmitter.
Every Hour (910)
1. Set the switches to “000” – Press and release the test
button. The LED should turn to Amber. The unit is
now in the programming mode.
2. Set the switches to “910” – Press and release the test
button, the LED should turn to Green for two
seconds. A State of Health Message will be sent
every hour.
Every Two Hours (911)
1. Set the switches to “000” – Press and release the test
button. The LED should turn to Amber. The unit is
now in the programming mode.
2. Set the switches to “911” – Press and release the test
button, the LED should turn to Green for two
seconds. A State of Health Message will be sent
every two hours.
Every Six Hours (912)
1. Set the switches to “000” – Press and release the test
button. The LED should turn to Amber. The unit is
now in the programming mode.
2. Set the switches to “912” – Press and release the test
button, the LED should turn to Green for two
seconds. A State of Health Message will be sent
every six hours.
Every Twelve Hours (913)
1. Set the switches to “000” – Press and release the test
button. The LED should turn to Amber. The unit is
now in the programming mode.
2. Set the switches to “913” – Press and release the test
button, the LED should turn to Green for two
seconds. A State of Health Message will be sent
every twelve hours.
Amber
Turns
Green
for 2 Sec
Amber
Turns
Green
for 2 Sec
Amber
Turns
Green
for 2 Sec
Amber
Turns
Green
for 2 Sec