User's Manual

©QTI Page 18 Revision: F
Form #: 30Z0138 Effective Date: 24 August 2006
EMIDS Transmitter (MMCT) Programming
State of Health Messages (cont.)
Every Twenty-Four Hours (914)
1. Set the switches to “000” – Press and release the test
button. The LED should turn to Amber. The unit is
now in the programming mode.
2. Set the switches to “914” – Press and release the test
button, the LED should turn to Green for two
seconds. A State of Health Message will be sent
every twenty-four hours.
State of Health Messages Disabled (915)
1. Set the switches to “000” – Press and release the test
button. The LED should turn to Amber. The unit is
now in the programming mode.
2. Set the switches to “915” – Press and release the test
button, the LED should turn to Green for two
seconds. A State of Health Message are disabled.
Program 930 to 934: Serial Port Baud Rates
These programs are used to set the baud rate of the serial port.
Warning: If the serial port is activated, the power down option must be disabled. (See Program 908)
Baud Rate 9600 (930)
1. Set the switches to “000” – Press and release the test
button. The LED should turn to Amber. The unit is
now in the programming mode.
2. Set the switches to “930” – Press and release the test
button, the LED should turn to Green for two
seconds. Baud rate is set at 9600.
Baud Rate 4800 (931)
1. Set the switches to “000” – Press and release the test
button. The LED should turn to Amber. The unit is
now in the programming mode.
2. Set the switches to “931” – Press and release the test
button, the LED should turn to Green for two
seconds. Baud rate is set at 4800.
Amber
Turns
Green
for 2 Sec
Amber
Turns
Green
for 2 Sec
Amber
Turns
Green
for 2 Sec
Amber
Turns
Green
for 2 Sec