User's Manual

©QTI Page Revision: F
Form #: 30Z0138 Effective Date: 24 August 2006
4
EMIDS Receiver (MMCR) Display
Display located on the front of the MMCR.
Top Indicators (Receiver Related)
Active Channel - Indicates there is either a signal or noise on the selected channel.
Lockouts Enabled - Indicates that the programmed lockouts are activated.
Receiver Batt Low - Indicates that the batteries in the receiver should be replaced.
Center Indicators
ID Codes – ID Codes received by the receiver from the transmitter.
Channel – Displays the current channel for two seconds when turned on, or when going to the operational mode
from the programming mode.
Programming Mode – Displays options when in the programming mode.
Bottom Indicators (Transmitter Related)
LÆR – Indicates target movement from left to right (when used with DAOR Switch).
RÆL – Indicates target movement from right to left (when used with DAOR Switch).
LÆR RÆL – Indicates a sensor fault.
TAMP – Indicates the transmitter was tampered with.
TEST – Indicates the test button on the transmitter (MMCT) was pushed or a state of health message was received.
LOBATT – Indicates the batteries in the transmitter should be replaced.
Channel
Active
Lockouts
Enable
d
LÆR RÆL TAMP TEST LOBATT
Receiver
Batt Low