User's Manual

©QTI Page Revision: F
Form #: 30Z0138 Effective Date: 24 August 2006
6
EMIDS Receiver (MMCR) Programming
LOCKOUTS
First Time Setup for Group Lockouts
Press and hold the push button in. Turn the ON/OFF switch clockwise to
the ON position.
Release Button – (If already in Menu Mode disregard). To select
Lockouts (LO) rotate knob until the “LO” appears.
Press button – “On” will be displayed.
To enable lockouts press button when “On” is displayed – “LO1” will be
displayed.
Rotate knob until the desired lockout group is displayed. In this example
it is LO2. Press button.
To enable lockouts in LO2 rotate the knob until “On” is displayed. Press
button – display changes to ??
Press button.
Rotate knob until the first number of the Low ID of the group is displayed
(if using standard MIDS it will be a blank, to set a blank rotate the knob
clockwise slightly past the “9”) – Press button.
Set the second number by rotating the knob until the desired number
appears – Press button
Rotate knob until the last desired number appears – Press button.
ID 24 is now set as the low ID in LO2 group.
Rotate the knob back to LO2 and press the button.
Press button.
To confirm Low ID rotate knob counter clockwise – the ID programmed
in the previous steps will appear – rotate knob clockwise until ?? appears
– press button.
“_ _ _” appears in the display window.
Rotate knob until the first number of the High ID appears – Press button.
Rotate knob until the second number is displayed – press button.
Rotate knob until the third number is displayed – press button.
If “End” is not displayed rotate the knob until “End” appears. Press
button – return to menu.
Rotate knob until “End” is displayed – press button.
Operating mode – “Lockouts Enabled” shown top center of display.
The MMCR must be returned to the operating mode to save the
changes. The saved changes now become the default settings when
the MMCR is powered up.
Button held in
Power On
Chn
LO2
On
LO
_ _ _
LO1
LO2
??
0--
02
-
024
LO4
Lockouts
Enabled
Chn
End
??
150
15
-
1
--
Note: The push button prompt means to
press the button and then release it.
Individual ID Lockouts
Follow the same steps as group lockouts,
except the desired lockout (ID Code) is
inserted in both the low and high settings.
To confirm group lockout:
Rotate the knob to “LO” press button- “On”
press button. Rotate knob to “LO2” (lockouts
enabled). Press button. Rotating the knob
will display the Low and High ID of the
Group. The lockouts can be turned “On” or
“OFF” at this time.
Antenna
Push Button
RS232
Port
Ear Phone
Jack
On/Off Switch
Volume Control
Menu Selection &
Programming Knob
_ _ _