User's Manual

QTI Page 14 of 15 Revision: D
Form #: 30Z0250 Effective Date: 1 August 2010
Section 4: Maintenance
OPERATOR MAINTENANCE:
The MCDT has been designed as low cost low maintenance equipment. All components are conformal
coated which reduces the amount of maintenance required. The only required operator maintenance is
to inspect the equipment for damage and keep the equipment clean of dirt, grime, and caked on mud.
NOTE: Do not submerge the equipment in water. This could result in damage.
DEPOT MAINTENANCE:
Upper echelon maintenance will be performed by the supplier of the equipment. If the equipment is
beyond the user capability to repair, it can be returned to the supplier for test and evaluation. Upon
completion of the inspection, the supplier will notify the user if the unit can be repaired. If the
equipment is not covered by the warranty, an estimate will be provided for repair costs. If the
equipment is not repairable, the supplier will specify replacement costs. (Note: See warranty below for
return procedures.)
EQUIPMENT STORAGE:
Upon return to the facility, clean equipment as noted in operator maintenance above. After cleaning,
return the equipment to the storage cases. Store the unit in a dry environment, preferably at room
temperature.
WARRANTY:
Qual-Tron, Inc. guarantees all products to be free from defects in materials and workmanship for 12
months from the date of purchase. Damage due to misuse, accidents, lightning strikes, unauthorized
service, environmental conditions beyond the equipment specifications, acts of war or damage other
than fair, wear and tear is excluded from this warranty.
RETURN PROCEDURES:
For support and service, please contact the following. To return any material, contact Qual-Tron, Inc.
to receive a Return Material Authorization (RMA) number. Once an RMA number has been assigned,
ship the material to the address below and reference the RMA number on the packing slip. Qual-Tron
will return the equipment as quickly as possible to the user.
QUAL-TRON, INC.
Attn: Sales Ph: 918-622-7052
9409 E. 55
th
Place Fax: 918-664-8557
Tulsa, OK 74145 email: sales@qual-tron.com
TROUBLESHOOTING GUIDE:
Defect Possible Cause Corrective Action Stage
Area
Empl
Site
Will not turn on Low voltage Check power supply X
Does not
receive/transmit
alarms
Low voltage Check power supply X
Transmitter & receiver too
close to each other
Experiment with antenna
combinations (with & without)
X X
Frequency Verify transmitter and receiver are
on the same frequency
X
Receiver not enabled Verify receive mode is on X
Wrong message format Check TRSS mode X