30cc Petrol Grass Trimmer Original Operating Instructions EASY PULL STARTING SYSTEM WITH ROTOCHOKE. Quick and easy to start. 43CM GRASS TRIMMING CUTTING WIDTH. Large diameter for fast and easy trimming. POWERFUL 30CC 2 STROKE PETROL ENGINE. Ideal for medium to large gardens. TWIN-LINE BUMP-FEED SPOOL. Automatic line feed for continuous trimming. ADJUSTABLE FRONT HANDLE AND CARRY STRAP. For greater control and comfort. AFTER SALES SUPPORT UK / IRELAND HELPLINE NO 0151 6491500 REP.
Contents 03. Safety Guide 06. Assembly and Parts list 12. Getting Started 14. Operation 19. Trouble Shooting 22. Declaration of Conformity 23. Guarantee Certificate 02 Helpline No.
1 2 3 4 5 Explanation of the information signs on the equipment: 1. Warning! 2. R ead the instructions for use before operating the equipment. 3. W ear safety goggles, a face guard and ear defenders. 4. Wear sturdy, non-slip footwear. 5. Wear safety gloves. 6. Protect the equipment from rain and damp. 7. Be careful of objects being thrown out! 8. A lways switch off the equipment and pull out the spark boot plug before carrying out any maintenance work. 9.
Safety Information Handling 1. R ead the instructions with due care. Familiarize yourself with the settings and proper operation of the machine. 2. N ever allow children or other persons who are not familiar with the operating instructions to use the petrol grass trimmer. 3. N ever mow in the direct vicinity of persons especially children - or animals. Warning: Maintain a safety distance of 15m. If approached, switch off the appliance immediately.
bystanders and also damage equipment. If an object is hit accidentally, turn the engine off immediately and examine the equipment. Never operate unit with damaged or defective equipment. 16. Always trim or cut at high engine speeds. Do not run engine slowly at start or during trimming operations. 17. Do not use equipment for purposes other than trimming or mowing weeds. 18. Never raise the line spool above knee height during operation. 19.
A B 06 C Helpline No.
D E F1 F2 G G1 Helpline No.
08 G2 G3 H H1 H2 I Helpline No.
J1 J2 K1 K2 L M1 Helpline No.
M2 M3 M4 N1 N2 N3 Helpline No.
N4 N5 N6 N7 O1 O2 Helpline No.
Important! When using the equipment, safety precautions must be observed to avoid injuries and damage.Please read the complete operating instructions and safety regulations with due care. Keep this manual in a safe place, so that the information is available at all times. If you give the equipment to any other person, hand over these operating instructions and safety regulations as well.
4. Technical data Engine type: 2-stroke engine, air-cooled, chrome cylinder Engine power (max.): 0.76 kW/1.03 hp Displacement: 29.7 cc Idle speed of engine: 2900 rpm Max. engine speed: 11000 rpm Max. twin line speed: 8000 rpm Ignition: Electronic Drive: Centrifugal clutch Weight (with empty tank): 5.8 kg Long handle length: 135 cm Cutting circle diameter of line: Ø 43 cm Cutting line length: 5.0 m Cutting line diameter: 2.0 mm Tank capacity: 0.
5.3 Fuel and oil Recommended fuels Use only a mixture of normal unleaded petrol and special 2-stroke engine oil. Mix the fuel mixture as indicated on the fuel mixing table. Please note: Do not use a fuel mixture which has been kept for longer than 90 days. Please note: Do not use 2-stroke oil with a recommended mixing ration of 100:1. If inadequate lubrication causes engine damage, the manufacturer’s engine warranty will be voided.
6.3 Switching off the engine Emergency Stop procedure: If it becomes necessary to stop the machine immediately, set the ON/OFF switch to “Stop” or “0”. Normal procedure: Let go of the throttle lever and wait until the engine has changed to idling speed. Then set the ON/OFF switch to “Stop” or “0”. 6.4 Practical tips Practice all operating techniques with the engine switched off before you start to use the machine.
WARNING: Do not remove any objects from footpaths, etc. using the trimmer. The trimmer is a powerful tool and can throw small stones and other objects a distance of 15 meters or more, causing injuries and damage to cars, houses and windows. (Fig. N4). • Wind the line with tension in a clockwise direction as shown in the illustration (Fig. N5), with the two halves being separated by the spool divider. Wind up all of the line down to the last 15cm of each end. 7.
Check the spark plug for dirt and grime after 50 hours of operation and if necessary clean it with a copper wire brush. Thereafter service the spark plug after every 50 hours of operation. 1. Pull off the spark plug boot (Fig. K1) by twisting. 2. Remove the spark plug (Fig. K2) with the supplied spark plug wrench. 3. Assemble in reverse order. 7.2.4 Grinding the safety guard blade The safety guard blade (Fig. L/Item F) can become blunt over time. Clamp the blade in a vise.
7.3 Storage Please note: If you fail to follow these instructions correctly, deposits may form on the interior of the carburetor which may result in the engine being more difficult to start or the machine suffering permanent damage. 1. Carry out all of the maintenance work. 2. Drain the fuel out of the tank (You can use a plastic petrol pump for this purpose, which can be bought via our HELPLINE 0151 649 1500). 3. When the fuel has been drained, start the engine. 4.
9. Troubleshooting FAULT POSSIBLE CAUSES TROUBLESHOOTING The machine does not start. - Correct starting procedure not followed. - Sooted or damp spark plug. - Incorrect carburettor setting. - Follow the instructions for starting. - Clean the spark plug or replace it with a new one. - Contact Helpline: 0151 649 1500 The machine starts but does not develop its full output. - Incorrect choke lever setting. - Soiled air filter. - Incorrect carburettor setting.
Please adhere to the following maintenance periods in order to ensure a failure-free operation. Important! Fill in engine oil and fuel before starting up the engine for the first . time.
Notes Helpline No.
