Operating instructions

11
Important!
When using the equipment, a few safety
precautions must be observed to avoid
injuries and damage. Please read the
complete operating manual with due care.
Keep this manual in a safe place, so that
the information is available at all times. If you
give the equipment to any other person, give
them these operating instructions as well.
We accept no liability for damage
or accidents which arise due to non-
observance of these instructions and the
safety information.
1. Safety information
CAUTION!
Read all safety regulations and
instructions.
Any errors made in following the safety
regulations and instructions may result in an
electric shock, fire and/or serious injury.
Keep all safety regulations and
instructions in a safe place for future use.
Explanation of the symbols on the machine
(Fig. 26):
1 Important! Read the operating instructions.
Follow the warnings and safety instructions.
2 Important! Risk of injury from rotating parts.
Keep your hands, feet and clothing away
from these parts.
3 Always make sure that the machine is
standing solidly whenever you leave it.
4 Important! Hot machine parts. Keep your
distance.
5 Important! Switch off the engine before
refueling.
6 Description of the clutch lever: 0 = tiller blade
”Stop”; 1 = tiller blade “On/Run”
2. Layout (Fig. 1-3)
1 Holder for steering handle
2 Transport wheel with holder
3 Engine / gear unit
4 Depth stop
5 Steering handle – throttle lever
6 Steering handle – clutch handle
7 Hand pull starter
8 Clutch handle
9 Bar for spark plug wrench
10 Spark plug wrench
11 Safety split pin for depth stop
12 Resetting spring for transport wheel
13 Four screws size M6 x 30mm for fastening
the steering handle
14 Four screws size M6 x 20mm for the
steering handle holder
15 8 x nuts size M6
16 Four M6 washers
17 Four M6 spring washers
18 Four large M6 washers
19 Screw size M8 x 80mm
20 Nut size M8
21 5 x Screw size M6 x 35mm
22 Domed nut size M6
23 Safety split pin for resetting spring
24 Open-ended spanner size 10/12
25 Open-ended spanner size 13/15
26 Cross strut
27 Clutch Handle Lock
3. Proper use
The machine is designed for digging over beds
and fields. Be sure to observe the restrictions
in the safety instructions (Section.1. Page 3).
The machine is to be used only for its
prescribed purpose. Any other use is deemed
to be a case of misuse. The user / operator
and not the manufacturer will be liable for
any damage or injuries of any kind caused
as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or
industrial applications. Our warranty will be voided
if the machine is used in commercial, trade or
industrial businesses or for equivalent purposes.
Helpline No. UK 0151 649 1500 / IRE 189 094 6244