User's Manual

NOTE: Clicking on the Make Windows your default Power On experience in this dialog box disables
Instant Web. For more information on disabling and enabling Instant Web, refer to
Disabling and
enabling HP Instant Web on page 7.
Disabling and enabling HP Instant Web
You can disable or reenable Instant Web in two ways.
To disable or reenable Instant Web from the Windows operating system:
1. Click Start > All Programs > HP Instant Web. The HP Instant Web Installer folder displays.
2. Click HP Instant Web Configuration Tool.
3. Select the Enable HP Instant Web check box.
4. Click OK.
NOTE: The HP Instant Web Configuration Tool can also accessed by clicking Start > Control
Panel.
To disable or reenable Instant Web from within Setup Utility:
1. Open Setup Utility by turning on or restarting the computer. Immediately press f10 repeatedly to
enter Setup Utility.
2. Use the arrow keys to select System Configuration.
3. Use the down arrow key to select HP Instant Web Support, and then press enter.
4. Use the arrow key to select Enable or Disable, and then press enter.
5. Press enter to confirm your change.
6. To save your change and exit Setup Utility, use the arrow keys to select Exit, select Exit Saving
Changes, and then press
enter.
Disabling and enabling HP Instant Web 7
Antenna House XSL Formatter (Evaluation) http://www.antennahouse.com/