User's Manual
Table Of Contents
- Contents
- About this Document
- Introduction
- AP Network Attachment and Configuration
- AP Web Server
- Regulatory Compliance Information
2
Chapter
2-2 • AP User’s Guide Atheros Communications, Inc.
2-2 • March 2003 COMPANY CONFIDENTIAL
2. Connect the optional RS-232 port to the HPC serial port through a serial
cable. Refer to Appendix C for more information on the serial interface.
3. Plug in the provided power supply to the AP power supply connector.
Network Configuration
Follow these steps to configure the HPC for AP network control:
1. From the HPC’s Start menu, choose Settings and open the Network and
Dial-up Connections dialog box.
2. Right-click on the Local Area Connection icon that belongs to the Ethernet
controller connected to the AP, and select Properties.
Figure 2-1. Access Point to HPC Connections
Power
Supply
Ethernet
Hub/Switch
Atheros Access Point
Host PC
(HPC)
Ethernet Port
Ethernet
Port
Power
Ethernet Cable
Ethernet
Cable
(AP)
RS-232
Port
RS-232
Port
Optional
Serial Cable