User's Manual

80 - Memory Upgrade Module
7 Insert the memory upgrade module at a 45° angle. Press the connector edge of the module firmly down and
into the connector until it lodges under the retaining clip. You’ll hear a click when it is properly in place.
8 Replace the cover and reinstall the screw.
Removing a Memory Upgrade Module
1 Perform steps 1 through 4 of Installing a Memory Upgrade Module.
2 Pull the clips sideways away from each side of the memory upgrade module at the same time.
3 While holding the clips out, remove the module by lifting it up and pulling it away from your Tablet PC.
4 Store the memory upgrade module in a static guarded sleeve.
5 Replace the cover and reinstall the screw.
Figure 34. Opening Memory Compartment Figure 35. Installing a Second Memory Module
Memory Compartment Screw
Retaining Clip
2
1
Alignment Key
THE MEMORY UPGRADE MODULE IS NOT SOMETHING YOU ROUTINELY REMOVE FROM YOUR TABLET
PC. O
NCE IT IS INSTALLED, YOU CAN LEAVE IT IN PLACE UNLESS YOU WANT TO CHANGE SYSTEM
MEMORY CAPACITY.
Sparrow T580.book Page 80 Friday, October 1, 2010 9:11 AM
DRAFT