User Manual

Feature Configuration
80-VT321-1 B 10 Qualcomm Confidential and Proprietary
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
Command Description
aniSdkTool –g rad Provides current channel and bandwidth information
aniSdkTool –s chn 0 X Y
1
Sets the channel; channel X is the primary channel and Y is the secondary
channel.
Channel Y must equal X +/- 4; the primary channel will be used in 20 MHz
mode, and for beacons and management traffic in 40 MHz modes.
In 40 MHz mode, the signal will be centered at (X+Y)/2
aniSdkTool –s bond 0 0
Turns off 40 MHz mode; the “aniSdkTool –s rte 0 X” command shall be
issued after this command
aniSdkTool –s bond 0 1
Turns on 40 MHz mode; the “aniSdkTool –s rte 0 X” command shall be
issued after this command
aniSdkTool
Lists all available API configuration commands; if you have any questions
about commands not mentioned above, contact your Qualcomm support
personnel
1
2
3
5
6
7
NOTE
No aniSdk Tool –s command takes effect until an aniSdk Tool –s cga command has been
issued.
NOTE
The output of aniSdkTool –g only accurately reflects the state of the system after an
aniSdkTool –s cga has been issued. Prior to the issuance of aniSdkTool –s cga, the result of
aniSdkTool –g may reflect settings that are pending but have not yet taken effect.
4.2 Configuring the STA 4
The client driver is based on WEXT.
When logged in, the commands listed in Table 4-2 are useful.
Table 4-2 Useful commands while logged in to the STA
Command Description
wpa_cli –iwlan0 status Provides status of wlan0
wpa_cli -iwlan0 remove_network 0 Removes your default network
wpa_cli -iwlan0 add_network 0 Adds a network (0) to connect to
wpa_cli -iwlan0 set_network 0 ssid '"your_ssid"' Sets your network’s SSID
wpa_cli -iwlan0 set_network 0 proto WPA Sets your network’s security protocol to WPA
wpa_cli -iwlan0 set_network 0 key_mgmt NONE Sets your network to open (no security)
wpa_cli -iwlan0 enable_network 0 Enables your default network
iwpriv set_clone_addr 00:de:ad:be:ef:00 Clones Agent PC’s MAC address to STA
iwpriv get_clone_addr Gets cloned MAC address
wext-conf save all Saves and persists the configuration on the STA
1
The available channels are governed by regulatory law. The STA hardware contains an ISO country code
programmed into EEPROM which defines the operational channels for a given regulatory domain. For
operation in countries governed by FCC regulations, operation in the 5150 to 5250 MHz band is limited to
indoor use.