User Manual

WCN1320 DC544D Family Modular Installation Guide Modular Installation
80-VT856-1 Rev. A 9 Qualcomm Confidential and Proprietary
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
2.2 Product labeling
The DC544D radio transmitter module is authorized only for use in a device where the antenna
may be installed so that 20 cm can be maintained between the antenna and the users. End user
products containing DC544D modules MUST
have affixed to their labels the following phrase:
This product contains FCC ID: J9C-DC544D1 or J9C-DC544D2 or J9C-DC544D3 module
2.3 Product usage
This device is intended only for OEM/ODM integrators under the following conditions:
1. The antenna must be installed so that 20 cm is maintained between the antenna and users.
2. The transmitter module may not be co-located with any other transmitter or antenna.
Use only authorized antenna(s) as described in the FCC filing under FCCID: J9C-DC544D1 or
J9C-DC544D2 or J9C-DC544D3.
The OEM/ODM integrator is responsible for testing their product for any additional compliance
mandates required when this module is installed within an end user product.
i IMPORTANT NOTE: In the event that these conditions cannot be met, then the
FCC authorization is no longer considered valid and the FCC ID number cannot be
used on the final product and thus the OEM/ODM integrator will be responsible
for re-evaluating the end product (including the transmitter) and obtaining a
separate FCC authorization.
2.4 Product documentation
The following RF exposure information shall be supplied in the end user manual for products
containing the DC544D PCIe daughter cards:
i IMPORTANT NOTE: To comply with FCC RF exposure compliance
requirements, the antennas used for this transmitter must be installed to provide a
separation distance of at least 20 cm from all persons and must not be co-located or
operating in conjunction with any other antenna or transmitter.