User's Manual

Requirements and Setup
80-VT830-1 C 10 Qualcomm Confidential and Proprietary
MAY CONTAIN U.S. AND INTERNATIONAL EXPORT CONTROLLED INFORMATION
1
Figure 2-2 Basic DFS test setup diagram for WCN1320 Ethernet-based AP 2
2.2 AP and client setup 3
4
2.2.1 Qualcomm AP setup 5
1. After powering ON both the laptops and the Qualcomm Master device, connect USB 6
connector of Keyspan adapter to USB interface of LP2. 7
2. Wait for 3 to 4 seconds, the LP2 will give a sound indication for the USB device detection. 8
3. Open the “Tera Term Pro” console application from desktop of LP2. 9
4. Configure the port as COM2 from Tera Term Pro -> Setup->Port. 10
5. If Qualcomm Master Device is a PCIe AP/Router then configure / set the baud rate to 11
115200 from Tera Term Pro -> Setup->Baud rate. If Qualcomm Master Device is an 12
Ethernet AP then configure / set the baud rate to 38400 from Tera Term Pro -> Setup->Baud 13
rate. 14
6. Connect the serial connector of Keyspan adapter to serial port of Qualcomm Master Device. 15
16
LP-2 (HP)
LP-1 (IBM)
Qualcomm WCN 1320 -
based Ethernet
AP
(
Master Device
( D
Keyspan Serial
to USB Adapter
Serial Port
( DB - 9 ) LAN ports
5
Volts power in
USB interface
Power in
5
Volts power adapter HP power adapter
IBM
power
adapter
USB interface
AC
Mains
Linksys
WUSB 600 N Client
( Slave Device )
Power in